(adsbygoogle = window.adsbygoogle || []).push({}); Hey guys, I am trying to change nat type from strict to open, but I can't access my router
Take a look at this: You must login or register to view this content.
I have a get router and types admin for username and admin for password, but it doesn't seem to work. I have also tried my get router name and my wpa key, but no luck so far.
This is also annoying because I want to port formward and make my own non-hamachi minecraft server. My last telenor router also had this problem :/
If it matters, the up-speed is about 40mb and the down 10.
Thanks a lot for helping

Have you tried "admin" and no password? Or "admin" and password as "admin?"

Typically you can reset your router to factory settings and then the default login will work. Find info on your router here:
You must login or register to view this content.

Once you get into the router, here is my guide for opening your nat.




You must login or register to view this content.

Hopefully this helps.

I've tried both, but none of them works :/
It just keeps on asking for password/username. I tried both and this is what happened: I entered the password/username and pressed enter, then it flashes for a millisecond and I have to enter password/username again :/

Sounds like the default username/password combo was changed. Check out the vendor's website on how to change or reset it back to the default settings. What's the model number of your router, I'll see how I can help you find the proper info. :y:

I had strict but then i checked youtube and i did it you go on a website and you change it