(adsbygoogle = window.adsbygoogle || []).push({}); Hello,

I have been able to successfully add a supercharger to the car of interest, but the problem is that its now impossible to remove that supercharger in-game.

Basically, I would like to add the supercharger part to a car that the game will not normally allow, and the most important thing is I want it to show up in the parts list for later removable / re-installation.

The car im trying to build is a Honda CR-X SiR '90, with a Honda Integra Typer-R DC5 '04 engine along with the supercharger from a Mazda RX-8 Type S '07.

Any tips?

Cheers

Only way to remove it again is through hex, just FF it out.

If you want to remove it why did you put it there in the first place though?

For a quick fix to your problem, copy settings onto sheet B and then take off the supercharger in hex.

So you have 2 tunes, one with the charger, one without.

It is possible to remove it by installing turbo.

And if you change the installed parts code where SuperCharger is a bit higher the mark will disappear from stock turbo so it's possible to reset even without installing 1,2,3 stage turbos.



Agree



Or just ingame to be faster

EDIT:

    

00FF0000 00000000 00000000 00000000 00000000 0A000000 

00000000 00023B00 00000000 00000000 00000003 FFFFFF00 

01000042 41014800 01004400 01020000 00004000 00000000 

[COLOR="#FF0000"]54[/COLOR]000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000001 04014000 

00000000 0002F652 617A6572 6D616E05 00000000 00000000 

00000027 00330002 00000027 00340002 00000AC3 000004A5 

00000847 [COLOR="#FF0000"]00000A32[/COLOR] 000008EC 00001092 00001148 000012BC 

0000000A FFFFFFFF 00000845 FFFFFFFF FFFFFFFF FFFFFFFF 

0000091D FFFFFFFF 00000CB8 FFFFFFFF FFFFFFFF FFFFFFFF 

0000002C 0000000E 000002F6 [COLOR="#FF0000"]000000B8[/COLOR] FFFFFFFF FFFFFFFF 

FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF 

FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF 

0BB80C5E 08040588 044F0366 00000000 00000000 00000000 

10AA0010 AA000101 00000000 00000000 00000096 00960014 

22104B4B 01010101 01010101 01013200 1E000000 0615150B 

0B000028 00000064 00000100 00640505 01000000 006403E8 

0000272A 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 00000000 00000000 00000000 00000000 00000000 

00000000 000000

Why: The flexibility. I want the car to act like a legit car, that I can tune. I don't always want the supercharger, I just want that option. Perhaps I want it in one race, and not another. Sometimes I might need another 30PP.

The settings sheet swapping method sounds like a good compromise

Yeah razerman, I know it uninstalls if you buy one of the original turbo's, but I was worried that it might completely remove it on all sheets.

But yeah, just use 2 sheets man...

Just out of curiosity, what is the highest exponential supercharger value?? the largest turbo value is 1443 without getting over 2000hp which is awesome... anyone know?

Ok

Yeah it removes it as you are not allowed to use both. Of course all sheets are unique and have their own settings.

I had a thought.

If I have added a new engine, and a supercharger - and changing setting sheets is meant to remove the supercharger, wouldnt it also remove the new engine?

I don't think you can remove engine with part change. Your engine swap should stay. Unless if you copy sheet where the Engine isn't swapped.