(adsbygoogle = window.adsbygoogle || []).push({}); Hi, I brought an E3 flasher the other day and I installed it. It all was going well and I made a backup of my ps3 NOR but when I tried to check it with the NOR dump checker it said it completed but with error, check HW. So I checked all my connections again and now the flasher itself wont update and it gives me three blinking lights when I try to make another NOR dump. Not sure what the problem could be because I have checked all the connection over 4 times and made sure there is enough pressure on the NOR clip and I have soldered point A to SBCE and the trans to SBE. Hoping someone can help.

Thanks

which led are blinking ? put a 1 on the blinking led and a 0 in the other one :

x|x|x|x|x|x|x|x

the error code are :
10000100 E3 internal Nor flash initialize fail
10000101 E3 internal Nor flash read fail
10000110 E3 internal Nor flash erase fail
10000111 E3 internal Nor flash write fail
10001100 PS3 BIOS initialize fail
10001101 PS3 BIOS read fail
10001110 PS3 BIOS erase fail
10001111 PS3 BIOS write fail
01000000 TF initialize fail
01001000 TF card open fail
01000100 TF read fail
01001100 TF write fail
11000000 Function switch setting error
11001000 PS3 version wrong, not support
11000100 Not current backup PS3
11001100 Wrong setting

i got 11000100

forgot to quote

you should probably try to reconnect the clip.
it is very capricious.
havn't got any other idea

tried that and tried to sand it down so it was connected properly but same thing

did u update your E3 flasher to the latest version ?
try to update it if not done and try to dump agian

yeah i did update it before anything. now i cant re update it and its just giving me that error