(adsbygoogle = window.adsbygoogle || []).push({}); OKAY! here's the full story! I really need to fix this please!

How it happened;
Okay so I was downgrading my ps3 fat cech-K03 the no FSM dongle & no esata dock needed way iv done it this way like 5 times always has gone fine, any how, I was downgrading and I got all good backup dumps I got 2, patched one and went to flash it back on... 'It went on fine, no errors on the e3, when I powered down the ps3 to plug in the HDD, I was receiving a ylod symptom. Wouldn't turn on , no safe mode.

What I did/tried:

Okay so I tried soldering a wire to the nor tristate to the e3 ribbon cable the sbe I think is called, and flashing the original back up back on, that didn't work. So I saw somewhere where you can solder to the nor tristate to GND and tried flashing original backup and this way left me with soft brick I guess? Turns on, but only hard reset so there's no safe mode, no HDD activity, controllers won't work connected, no video or sound. Iv tired flashing original backup and even the patched back up in all different orders 1000000 , 00000000 and someone send me a backup to flash on then my own? But still left with same problem, I saw another thread where someone says make a new backup but when I try and I check in nor inspector I just get 5-6 lines of error, iv tried 3 different e3 ribbon cables still nothing as soldering the nor tristate to gnd worked last time iv left it this way and I have disconnected it every time after a backup was flashed back on, its still the same!

I have a esata dock but not a esata cable okay and I have the e3 that's all but I always have done it the way so you only need e3 and e3 ribbon cable.

PLEASE PLEASE HELP ME WITH THIS PROBLEM

Someone help???

Modders? Help

Surely someone?

did you try simply flashing pup by entering fsm with dongle and doing the update with the pup on root of usb? power on then press eject routine?

How do I do that? How do I enter FSM?

I have a tutorial that might help! Check it out!