(adsbygoogle = window.adsbygoogle || []).push({}); I want to know how i would go from 4.66 HABIB back to 3.55 cex so i can go back to rebug, swap flashes etc and go back to ita dex once a spoofer is made (if one does get made)

My way of doing it is like this

im on 4.30.2 rebug (for other reasons)

so it would go like 4.30.2 rebug rex (swap to cex)>4.66 habib cex>Rebug 3.55.4 '999' Downgrader>Rebug 4.30.2 (swap to dex)>4.50 ita dex is this method of switching CFW fine? no brick problems?


-Thanks an advance!

Hmm im not sure how good rebug downgrader is or if it will work but it should do the job but you could also use Rogero 3.55 downgrader, also there is always a chance to brick switching cfw's and going from cex to dex or dex to cex so be careful!

Also maybe some slight problems i know that for the rogero downgrade cfw when you are on it you have to toggle qa and install a certain 3.55 cfw then you can go to the desired cfw it might not be the same with the rebug downgrade cfw or not, So im not sure if you can go straight from rebug 999 3.55 to rebug 4.30.

ok thanks for the reply

you can also use this You must login or register to view this content.
if u use this steps u can get on any other firmware