(adsbygoogle = window.adsbygoogle || []).push({}); So I'm on rebug 4.70 cex... I'm trying to connect an Ethernet cable to my pc and share my Wi-Fi. When I test my ps3 connection it fails to obtain an ip. Any settings I'm missing? It's not a faulty cable and I shared the wifi properly.I have my network debug settings set to single..do I have to be on dex before I do this I was planning on switching over afterwards

You have ti do the network bridge on your computer. And while doing the settings on the ps3 you have to put the computers ip address.

I recommend looking up a tut on youtube so you can be easily guided through the steps.

If you want to connect through tmapi. You need to be on dex and what you're doing also requires you to be on dex. For you to use a wired connection you need the ethernet cable going straight in to your router. You cannot bridge a connection on cex like you can on dex.

Alright I'll switch to dex and try it

Switch to dex tutorial.

Well to convert to dex is pretty simple but hard at the same time.

Follow this tutorial i made and you will be on it no time.

go to rebug.me and get the latest rebug rex (NOT D-REX)

First thing to note is that if your currently on a Rogero cfw then please install a different cfw eg habibs 4.66 cfw
if your on a higher one than the latest rebug cfw

if your qa flagged then your ok JUST INSTALL VIA RECOVERY MENU NOT XMB

if your not qa flagged then use a 999 downgrader to go to 3.55 then qa flag and install the latest rebug in recovery menu

or if you cannot goto 3.55 then use my rebug4.65v1 (syscon changed to 6.66) then qa flag and install rebugs latest via recovery menu

1.put the latest rebug renamed to PS3UPDAT.pup in a folder called UPDATE. put that folder in another folder called PS3 and put that folder on the root of your usb stick.

2.Put the usb stick into the usb port closest to the drive (right side port) and turn on the ps3

3.Select UPDATE VIA STORAGE MEDIA

4.Once installed. Run REBUG TOOLBOX

Go to the utilities column (far right) and select Toggle QA Flag. Select ENABLE

Now go up twice to get you to Dump eid_root_key

select YES. screen will go blank and after 10 seconds you will hear 3 beeps and the system will re-boot

back into rebug toolbox & go to the DEX&CEX column (Second from the right) and select Rewrite target ID in flash.

Select yes. the screen will go blank then come back on

go up one to Swap LV2 Kernel

it will instantly swap kernel's and tell you it requires a restart

Once restarted enter REBUG TOOLBOX select System Information

You should now see LV2 Kernel and Target Type are now DEX

Yea I've done that I just have to switch over to dex takes like two minutes

Oh, k lol

You mind adding me on Skype in case I have any more issues...
Live: Juniorace96

Ill add you when i get round to it dude.

I'm on dex and still I get failed to obtain ip