(adsbygoogle = window.adsbygoogle || []).push({});
How To Upgrade Your PS Jailbreak Clone Dongle
*THE EASY WAY!*
This tutorial is for updating the dongle ONLY, please view my other post on Jailbreaking 3.50
For Users Who Have A Problem With Their Computer Not Recongnizing The Dongle..
Originally posted by galanoth
i found a solution for when your pc doesnt see the JB clone
it here:
You must login or register to view this content.
post #26 hope it helps for some of you who have the same problem as is did
BIG thanks to galanoth, saved me some time :whistle:
Originally posted by another user
WHEN FINISHED READ NOTE AT BOTTOM OF TUTORIAL FOR AN IMPORTANT STEP ON AVOIDING THE "Verify fail at 0x00CBC" OR ANY OTHER VERIFY FAIL CODES!
Originally posted by another user
BEFORE YOU EVEN START PLEASE TAKE A LOOK AT THIS!
THIS IS THE JAILBREAK CHIP YOU WILL NEED IN ORDER FOR THIS TO WORK!
You must login or register to view this content.
NOTE: THE SLIT IN THE CHIP WERE THE LIGHTS ARE!
Files you'll need:
(Use the AT90USBKEY file, not AT90USBKEY2 or any other file or this wont work..Ignore instructions too, thats an old tut for BlackCat boards.)
Upgrade Instruction:
*MAKE SURE YOU HAVE DOWNLOADED NEEDED FILES*
1.)
You must login or register to view this content.
2.) When installed,go to installation folder, namely Atmel\Flip 3.4.2\usb\, find libusb0.dll and libusb0_x64.dll, copy them to folder Flip 3.4.2\bin
3.) Then plug PSjailbreak into USB port in PC, the red green light will light up.
4.) Meanwhile PC reminds you that unusable unkown device found.
5.) Ignore it, wait for a few seconds, new hardware AT90USB162 DFU will be found, pc asks you to provide driver,
You must login or register to view this content.
6.) choose USB folder in Flip as the Install Path, for example Atmel\Flip 3.4.2\usb\
You must login or register to view this content.
7.) then the installation begins.
You must login or register to view this content.
8.) When the driver is installed, we can write on AT90USB162.
You must login or register to view this content.
9.) Run Flip, go to Device -> Select..., and choose AT90USB162
You must login or register to view this content.
10.) Then go to File -> Load HEX File...
You must login or register to view this content.
11.) Choose the HEX file you want to write into, (Choose one of the files provided at the top of the post)
Attention: HEX must be put in the English path so that it can be read
12.) Then you can see HEX file parsed shown in the left bottom.
You must login or register to view this content.
13.) Then go to Settings -> Communication ->USB, choose OPEN USB port.
You must login or register to view this content.
14.) Then the chip is open and ready to be written.
You must login or register to view this content.
15.) Check HEX File, make sure if it’s the right HEX that you want to write into.
Originally posted by another user
IF YOU GET THE VERIFY FAILED ERROR , CLICK THE "READ TARGET DEVICE MEMORY" TO READ THE CHIP , DO THIS 3-4 TIMES THEN CLICK RUN AGAIN!
16.) Choose RUN in the left bottom, then the chip is being written. It will be done in a few seconds. You will see Verify PASS in the left bottom when it’s finished.
You must login or register to view this content.
Now the chip has been written. Turn off Flip and unplug the PS jailbreak dongle out of PC.
Kudos to myself for finding a fix for the "Verify Failed Error"
Good Luck, Have Fun
SOTK