(adsbygoogle = window.adsbygoogle || []).push({}); Today PlayStation 3 homebrew developer Nightbird has released a Rebug 3.55.2 PSN Enabler and 4.25 Spoof v0.7r3 update package (PKG) for those using the Rebug PS3 Custom Firmware (CFW).


For this to work on your ps3 you must have or do the following.

1) You must already be using Rebug FW 3.55.2 to use this
2) If you have already installed Rebug's Official Update 0.7 before, you can still install this.

Some information about it
This package relies on you using Rebug's own CEX / DEX Selector to change between 3.55 and 4.25 (PSN access).

Here is a qoute from the devolper this is important infomation

I have used all original Rebug files and patched them manually. The 'version.txt' was pulled from the original 4.25 pup. Selfs and 'index.dat' were rebuilt using fail0verflow tools. 'vsh.self.swp' and 'vsh.self.cexsp' are correctly patched to enable PSN access, 4.25 spoofing and switching between Debug and Retail XMB modes without causing RSOD. There are basically 3 modes:

Mode: Normal XMB: Debug = no spoofing (3.55), no PSN access, has 'ebug' options in 'Settings'.
Mode: Rebug XMB: Debug = Spoofed (4.25), PSN enabled, has 'ebug' options in 'Settings'.
Mode: Rebug XMB: Retail = Spoofed (4.25), PSN enabled, no 'ebug' options in 'Settings'.

All above modes are tested working with Reactpsn.

Now to install this you must follow this guide below

Installation Instructions:

Before you install this package, make sure you are in 'normal' mode (3.55) and are not using any other spoofers. If you are, disable and uninstall them. If you have been using FckPSN, put your original 'CA27.cer' back. If you are already spoofed (rebug mode) using Rebug's CEX/DEX selector, use it again to change back to 3.55. Do this by pressing 'L1 + Cross(X)' within the selector. Status should say 'Normal Mode'. Exit selector and check system FW is 3.55.

Now install the 'Rebug_PSN_UPDATE_0.7r3_3.55.2.pkg' from the link below. If you get the message 'same version already installed, continue' select 'YES'.

Now run 'Rebug Unofficial PSN Update Package 0.7r3 (3.55.2)' from XMB (ignore the stuff about v4.11). Select 'YES'. You will get a message 'Update Complete - System Will Reboot'.

After reboot, go back into Rebug's CEX/DEX selector. Press 'L1 + Circle(O)' to activate Rebug mode. Press 'PS' button and exit the selector. System will reboot. Now check in system settings/info that your firmware version says 'version 4.25'.

If it does, you have done the above procedure correctly and you can now log in to PSN. You can also now uninstall 'Rebug Unofficial PSN Update Package 0.7r3 (3.55.2)' from XMB.

Note: If you haven't installed Rebug's CEX/DEX selector, you can find it in 'Install Package Files'/'PS3 Hard Disk'. Both versions 1.5.1 and 1.6.1 work fine. This is for Rebug 3.55.2 Firmware only

Downloads are below and here is what it looks like on the ps3 side of it

You must login or register to view this content.


You must login or register to view this content.

Download
You must login or register to view this content.

Here is the sYou must login or register to view this content.

Wow sick! , Looks nice .
Gonna download this for sure

have you used this yet

no i dont use most of the things on 3.55 just update the cfw when needed lol

this gave me red screen on death dot use this

---------- Post added at 09:40 AM ---------- Previous post was at 09:14 AM ----------

oh it actually does work just make sure u have dev blind enabled so u dont get rsod

red screen of death can be caused by anything hut its an easy fix mostly just turning your ps3 on/off will work but there is a rsod fix out there infact i posted a tut a few months ago and i also posted an update from it also just because you got rsod does not mean every1 else will

i know i reinstalled cfw then tryed again this time with dev blind enabled and it worked fine thanks

ok great to here m8 and enjoy