Post: How To Remove Xbox360 Warranty Sticker Without Messing It Up
Options
08-02-2010, 06:06 PM
#1
+tA.Daisho
Crumpets and tea?
-Hair Dryer
-Knife or (Exacto Knife, Box Cutter, etc.)
-Wax Paper
Step One:
Take your Xbox 360 Console and Remove the faceplate
[ You should see Microsoft Seal which is Silver [Old Version] or Multicolored [New Version] Both versions will work.
Step Two:
Get your Wax Paper ready to put the sticker on.
Step Three:
Plug in your Hair Dryer and put it on HIGH or HOT button, or the buttons to make it the Hottest and on High.
Step Four:
Heat up the sticker for about 7-10 seconds.
Step Five:
After the 7-10 seconds keep the hair dryer on it. While you are doing that use your other hand to slide your knife under the seal SLOWLY. If you go to fast it may ruin the seal.
Step Six:
After the seal is off, place the seal on the wax paper. When putting the Seal back on the Xbox, warm up the wax paper for 5 seconds with the hair dryer, you may even warm up the Xbox just to be on the safe side.
Trust me doing this is necessary, tinkering around inside your xbox is fun but its not worth losing your warranty.
08-02-2010, 06:23 PM
#2
psychobe@n
Guest
08-02-2010, 08:35 PM
#3
+tA.Daisho
Crumpets and tea?
Originally posted by n
Sorry but this is very very, old. Its so old that even the aztecs predicted that when the xbox came out you can do it this way.
I know, and yet people don't do it at all. They just peel the back off without even thinking about it.
Its always good to refresh the memories of people though.
08-02-2010, 10:55 PM
#4
namelesssboy
Grunt
good tutorial though 
08-03-2010, 12:24 PM
#7
The Low Key OG
still the same OG, but I've been low key
Copyright © 2026, NextGenUpdate.
All Rights Reserved.
