(adsbygoogle = window.adsbygoogle || []).push({});

Tutorial on How To Give Your Xbox LED lights with no soldering

First take apart your xbox

Tools need to take apart xbox 360


Tools Needed:
Very small flathead screwdriver or a flat point such as a kitchen knife or pushpin
Small Phillips head screwdriver
A torx style star head screwdriver size T10


how to open an xbox 360

Step 1. Disconnect ALL wires from xbox, once everything is disconnected hold power button in for 2 seconds to clear any electric charge left in the console

Step 2. Remove Hard Drive and any memory unit/cards you might have plugged into the console. You will remove the hard drive by pressing button on the hard drive and pulling
straight up.

Step 3. Remove the faceplate by gripping the top and bottom near the left side of the console(the side that the disc drive is on) and pulling firmly but slowly until it pops off, then repeat this on the other end.

Step 4. Remove top and bottom gray mesh panels by prying them off with any small objects by inserting them into holes on the sides of the xbox console at the left, middle, and right points where you can see the grey tabs and pushing in to release the catches.

Step 5. Separate top and bottom of white case by inserting flat head screwdriver or knife blade into the back of the console at the points shown in the picture. You should hear a pop when each one releases; go down the line starting from left to right. You should hold the side that you're starting on and start to separate the case pieces so that they don't click back together when you pop the tabs

You must login or register to view this content.

Step 6. Complete seperation of the case by using a fingernail to unhook the tabs on the front of the console starting on one end and working your way to the other side, there should be 4 tabs to release, after that's done the top of the case should just slide right off.

Step 7. Using your Torx T10 star screwdriver remove the 6 screws shown in the following picture, you don't need to remove any other screws even though there's a bunch on there

You must login or register to view this content.

Step 8. After all 6 screws are removed and SET ASIDE SO YOU DON'T LOSE THEM, flip the console over so that the remaining half of the white case is on top. Make sure that the metal part that you just unscrewed the screws from is facing down, on the table or ground, etc.

Step 9. Pull the white case straight up, it should seperate easily from the rest of the console, and set it aside.
From here you should see the "guts" of the console, you have the disc drive, cooling fan, motherboard, and a white guard to direct air flow in the console.

Step 10- remove the white guard to direct air flow.

your xbox should look like this:
You must login or register to view this content.

than add your LEDs
You must login or register to view this content.

were you can buy the LEDs

You must login or register to view this content.

You must login or register to view this content.



You must login or register to view this content.
You must login or register to view this content.
You must login or register to view this content.

You must login or register to view this content.

Thanks for the info man, great thread

Thanks for the feedback, I really appreciate it.

very nice post, but personally i dont recommend the aurora's. You can only see the lights at night. I went with some cold cathodes in my xbox and they are BRIGHT!

well that was quite interesting ty matey

I wouldnt do this, Id probally do something wrong an break my xbox, Put anyways cool tutorial

nice good cool wow

Nice shit info