(adsbygoogle = window.adsbygoogle || []).push({}); I have a zephyr board (the first elites with hdmi) I believe....
I have a male db25 end with about 2 feet of wires between the connector and the board...
I double checked all my connections they are all good...
I soldered to the bottom of the board it was easier for me, but I tried the top too...
All the wires are in the right spots. I have the resistors soldered to the connector, and the diode to the board with the black end toward the board...
I tried it with and without the resistors didnt matter...

Should the 360 boot the default dash with the jtag in place?

What could I be doing wrong since the flash wont read?

I tried in 4 different computers (from new to old) from win 98 to win 7...all gave the same problem could not detect flash...They were also all intel cpu's

The xbox still has the old style dash so I know it can be jtagged

Please help me

I forget, its been a while since it was all hooked up to the tv...but like i said its on the old style blades dash so it is exploitable

Have you installed the driver for flashing the NAND?

The one that comes in the nandpro20b zip? yes i have