(adsbygoogle = window.adsbygoogle || []).push({}); Today I started up my jasper I brought it to play my legit copies with a hdmi. I haven't used it in awhile since I mostly use my older modded 360 that only takes components. So I turned on my jasper it asked me for a firmware update I updated but didn't have my hdd connected so it saved into my internal memory. I started up my Fable 3 and noticed there was no sound so I wiggled the hdmi because sometimes it looses signal it's a cheap one off of amazon I purchased years ago. I wiggled the cable the screen blacks out for a about 2 seconds then the picture comes back, still with no sound I try again still no sound. I reboot the console start it up and there is no signal. I tested the hdmi to make sure it wasn't it and it worked perfectly fine on my ps3. So I tested the console and put my hd component cables and booted it up it worked perfectly fine. It doesn't however want to work with my hdmi I checked the hdmi socket and it appeared to be fine. Is there anything I can do to repair this problem or do I need a new 360, sending it out to microsoft is not an option since I removed the casing so the console stays cooler with the small fan I have blowing on it. Also the hdmi use to work fine with the jasper.