(adsbygoogle = window.adsbygoogle || []).push({}); i wasn't sure where to put this, but i really need some help. i am trying to make a device that will spray water when a sensor alarm is set off. My brother and i are really allergic to cats, but my brothers wife loves her damn cat. the little shit head climbs on our beds and sleeps, so we have to wash our bedding. Else we will never stop sneezing. so i was wondering if anyone out there can help us. i will post pics of what we have.
the sprayer
You must login or register to view this content.
the spy gear toy
You must login or register to view this content.
we will start with the sprayer, we opened it up to see how it works.
You must login or register to view this content.
we found that the whole sprayer is run by the black switch with the little blue button
You must login or register to view this content.
here is a side pic of the button.
You must login or register to view this content.
now the spy gear toy, we thought that we could use the power source from the toy going to the speaker, as like a activating the sprayer. but we are not sure on how to hook it up.
You must login or register to view this content.
this is the main unit with the speaker wire going out the side
You must login or register to view this content.
here is a pic of the insides of the toy with out the speaker attached.
You must login or register to view this content.
and here is a pic of the speaker.
You must login or register to view this content.
please help guys we are stuck. people that help will receive vbux. thanks guys

Hey thanks everyone for some good ideas and even the bad ones haha