Post: hello i have a problem With my ps3 i have a flasher end now dont no what to do
12-29-2012, 06:44 PM #1
(adsbygoogle = window.adsbygoogle || []).push({}); i have a ps3 fat 40gb cechj

i have downgrade it with

E3 Flasher Limited Edition voor PS3

with the Minimus AVR USB 32K dongle


now i but my flasher succesfully on my ps3 fat i hoped dat i only have to open the ps3 fat one time ..but after the six time it workt for me what i have done is i get 3 euro en i put it on the flasher en if you close your ps3 then the euros pressing at the flasher end the connechtion was good finnaly

now i start to downgrade mij ps3 40gb

update for the E3 Flasher's firmware succes


create your dump succes

Byte reverse succes

verify the dumps succes

installing the downgrade patch succes

Finishing the down grade in service mode succes now i have succesfully installed firmware 4.11 rogero i was on 4.30

De-hashing
Now to DeHash the console so it is brick protected when / if you decide to upgrade the firmware

THIS IS THE RECOMENDED WAY
QA flag method

so i put qa flag on my usb stick end i go intro servers mode
so i did it my holding mij on knop in then the ps3 go out en then i hit the on button still in thill i here 2 pieps
en then i go to nummer 6 update firmware i see that he dit succesfully install ofw 3.55 end when it finnist the ps3 fall out i wanted to put it on again but i see a green light en then a orange light en then the ps3 pieps 2 times en then it fall out do enyone can help me because iam stuck here

yes i have the orginal dump still on pc

i have fallowd thiss guide You must login or register to view this content.


sorry for my bad english i have done my best do let you understand what i say

thanks anyway for helping me
(adsbygoogle = window.adsbygoogle || []).push({});
12-30-2012, 02:58 PM #2
Hello now i no a way end my dad wanted to solder but do enyone now how to do that the good way ?

Copyright © 2026, NextGenUpdate.
All Rights Reserved.

Gray NextGenUpdate Logo