(adsbygoogle = window.adsbygoogle || []).push({}); I used rogero downgrade to 3.55, stuck on blue screen when I updated to 3.55 3.7 rogero? anyone know what happen or have a fix?

Moved to the PS3 Mods Questions and Inquiries section.

try to re-install 3.55 rogero3.7 through safe modus if possible?

Did you enable QA after you installed the downgrader PUP?

yes I enabled qa, couldn't begin update unless. I have jus a blue screen in recovery and blue on normal load. if I hit circle goes to a black blank page. I haven't played this ps3 in along time but im sure this couldn't only of happened to me. bad way to find out what the hell BSOD is lol

So i understand that you cannot access the recovery menu?

nope! well I think it does enter recovery, soon as it double beeps it goes to blue screen, if I hit circle the screen goes black

ok go to recovery menu even if it does blue screen, plug in your controller then press down on the d pad 5 time then wait a second then press start and select at the same time then wait it should up (put a different CFW on your usb PS3/UPDATE/PS3UPDAT.PUP) then just give it some time and it should load up a different CFW fixing your problem if that doesnt work take out your hard drive and put it in a different ps3 (this will make the hdd format) then put the hard drive back into your CFW ps3 and try to boot again

Are you sure it's not your HDMI cable which is the culprit??


I wouldn't recommend attempting to install CFW while blinded...

no its not the wire, I did try my component wires witch run original ps video output but still blue to black, I put the original 60gb hdd in it and everything works fine, swap back to 500gb and its blue again.