Post: Cex to dex brick - urgent help needed 3 bleeps on start up - please help please
05-24-2013, 06:37 PM #1
mw2clfree
Save Point
(adsbygoogle = window.adsbygoogle || []).push({}); Ok so i had a ps3 4.41 and i downgraded my ps3 to 3.55 with e3 flasher. Everything working fine (im on nor ps3 slim btw) and i installed rogeros 4.40 and then i decided i wanted to do real time modding, so i followed a tutorial and did everything as it said to convert my ps3 to dex.

I downgraded back down to 3.55 with my e3 flasher and then found my Eeid root key and did all that stuff, then i went on my computer and converted the files i had from cex to dex. The i updated back to rogero 4.40 and then i went back into multiman and flashed that file i had got from the cex to dex program on my ps3. then i turned my ps3 off and now it wont boot up. I press the on button once and it bleeps and does nothing. then i press it again and it turns on for a brief moment and does 3 bleeps not 5 and turns itself off.

I have tried with my e3 downgrade dongle to get it into factory service mode and i power and eject (e3 card reader in right side usb port) and no light appears on my e3 card reader, as it seems that the ps3 is shutting off before the e3 card readder can be read. No lights are shown when i boot the ps3 up please help i really am screwed.
(adsbygoogle = window.adsbygoogle || []).push({});
05-26-2013, 04:05 PM #11
Did you ever find what was the problem cause i have the same problem
05-26-2013, 04:25 PM #12
did u try going into recovey mode?
05-26-2013, 04:50 PM #13
cant reach recovery mode its just goes into the red light flashing

---------- Post added at 11:50 AM ---------- Previous post was at 11:49 AM ----------

Originally posted by prototype123 View Post
did u try going into recovey mode?


cant reach recovery mode its just goes into the red light flashing
05-26-2013, 08:02 PM #14
mw2clfree
Save Point
OK so i have acquired some help from ps3hax and they said that i needs to solder a wire from a particular place on my mother board (i do know the exact place, its different for different models of ps3 as they have different motherboards) to the ribbon cable on the e3 flasher, this will allow the e3 flasher to stay on while i try and restore a valid dump, then they say that it should fix the problem. ATM i am in the process of getting my dump checked and when that is checked i will need to wait until i can acquire some wire to perform this process and that will be at least probably around next week. So unfortunately i have to postpone getting the ps3 up and running, but i just hope to god that my dump was valid.
05-26-2013, 08:34 PM #15
what model ps3 do you have

Copyright © 2026, NextGenUpdate.
All Rights Reserved.

Gray NextGenUpdate Logo