(adsbygoogle = window.adsbygoogle || []).push({}); Ok so i have downgraded a lot of ps3's but today i did not toggle qa before downgrading, actually I selected toggle qa but i did not have the bd drive hooked up and I was left with a black screen. After i rebooted the light went from green to yellow for a couple seconds then turned off.

I soldered the tristate to grnd and reflashed my original backup dump and then unsoldered the tristate to ground. I then continued to the downgrade process.

Now my ps3 turns on with no audio or picture and yes i reset the video. I repeated the downgrade process with the same result no screen or audio.

I switched hdd and all. Cant seem to figure out what happened i use e3 flasher fsm method. and use this Rogero_3.55_v3.7_PS3UPDAT

can someone provide the steps i need to take?

you can send me your dump and I check whats wrong with it

try to boot the ps3 without hdd if it says something like cannot find system storage thing you just have to format the hdd in the pc to get it working again

I tried that and it says nothing still a black screen. I funflashed my original unpatched dump after soldering the tristate to ground then i put all switches down and flashed my original patched to it and continued the downgrade process and got into fsm but after all steps still a black screen. this ps3 worked perfect beforehand. Like I said i had it on rogero "the step before putting 3.55 on it" I then toggled qa without the bluray drive in on accident and it went to a black screen. and here I am!@

dont forget to turn on the tv, and connect an hdmi cable.

lol

I'm smarter than that lol. Still cannot figure this out.