(adsbygoogle = window.adsbygoogle || []).push({}); I am going nuts here,

Yesterday I installed LTS SPRX, all worked fine.

Turned off, then turned back on later and it looked like and old PS2 loading screen, it asked me to input date time ect as if it was a first time install.
I notice that Rofero was still installed, but all my users had an * next to them, but no sign in details, so when I go to sogn up as an existing user it constanly says TIMED OUT, error 80710007.

All my network settings are fine, but cant get on internet, aaaaaaaaaaaaaaaaaargh



HELLLLLLLLLLLLLLLP

Go into Debug Settings. Find NP Environment. Change it from Sp-int to NP.

Thread moved to PS3 Mods Questions and Inquiries.

You are the man< mwah lol

fancy helping me out with tmapi, there are 3 options i am told to change, but those options are not in my debug menu???


Setting up your PS3 for RTEing

Go to the settings column on the XMB menu and go all the way to the bottom to "Debug Settings" and make sure all the following setting are selected.

Release Check Mode > Development Mode
Boot Mode > System Software Mode
Network Settings for Debug > Single Setting

Make sure your PS3 is wired to the router via an ethernet cable or use Sharkbait's tutorial listed below to set it up wirelessly! This is very important or it won't show up in the target manager!

CCAPI is much easier to use and setup. I would recommend that to you. You need DEX/D-REX as well for TMAPI.

I am on DEX, but ccapi KEEPS FREEZING????

When does it freeze?

This is using LTS on PC, generally when i click anything, like heist button, clothing, car upgrades ect

The software does say use TMAPI???

LTS should support CCAPI. Try running it as Administrator. Also, did you allow the tool access to use the WiFi in order to find the console because CCAPI runs off of WiFi.