(adsbygoogle = window.adsbygoogle || []).push({}); I was flashing my ps3 with a fully tested with HXDEN/NORINSPECTOR and patched with PS3 flash tool. I was in the last two lights of the flashing process when I got an error code number 10001111 and found that my e3 sd card holder was messed up so I turned off the ps3 to fix it but when I tried to turn it back on the ps3 shut down on its own after a sec or two. I'm so lost on what I can do now to fix this and if this is a soft brick or a done for good brick? Any help?

You must solder a wire from the tristate to a ground. This will allow the console to boot enough that you can flash a good backup to it, in fun flash mode with e3 flasher.

Worked just like you said. PS3 is now at 100% again and I can finish the downgrade Thanks for your help