Post: **How to make a PS3 turbo controller**
Options
05-26-2010, 12:51 AM
#1
xPinnacle--
Who’s Jim Erased?
How to Make A PS3 Turbo Controller
1. Use the flathead screwdriver to remove the R2 button. This is just the plastic covering; it can be removed and popped back into place with no damage being done to the controller.
2. Remove the R1 button following the same instructions as in Step 1.
3. Remove the little circular piece of rubber from underneath the R1 button. Again, this action is reversible, so you do not have to worry about breaking the controller.
4. Locate and remove the circular rubber tab from underneath the R2 button.
5. Bend the paperclip into three sections about a half-inch long on each side. This should result in a U-shaped paperclip.
6. Bend the paperclip again, this time halfway up the vertical posts of the U-shaped paperclip. Think of two "7s" connected at the top by a horizontal bar.
7. Put the ends of the paperclip in each of the two holes that were created by removing the rubber tabs from Steps 3 and 4. Place it with the fat part of the paperclip coming off of the right side of the controller. This will allow your right hand to push down on the paperclip as if it were the R1 and R2 button together.
The following 9 users say thank you to xPinnacle-- for this useful post:
but somepeople might remember that the g3 is ALLREADY automatic in campaign on COD4 so 
06-05-2010, 10:43 PM
#25
xPinnacle--
Who’s Jim Erased?
06-06-2010, 07:30 AM
#26
jeffgordon24365
Bounty hunter
06-06-2010, 06:23 PM
#27
Geigers
Legal 
Originally posted by xUS.Marine187
Re READ STEP ONE. Or you did it wrong.
I did what the steps say and what im telling u is that u CANT remove the R2 button because it is attached to a little metal rod, if u did do this u would break off R2 completely and wouldnt be able to put it back on (for a ps3 controller)
06-06-2010, 07:03 PM
#28
Goutinator
Bounty hunter
Copyright © 2026, NextGenUpdate.
All Rights Reserved.
