Post: Downgrade Tutorial for Nano 1g from 3.50 to 2.10 to 3.41
Options
12-14-2010, 03:37 AM
#1
Sync
Guest
IpodNano1G-Downgrade Files: You must login or register to view this content.
1)Connect your iPod 1g Nano to your computer.
2)Drag PSGrade Folder into the root of the iPod Nano 1g.
3)AND replace your rockbox.ipod file in your ".rockbox" Folder with this one.
You must login or register to view this content.
4)Eject Ipod your done with the Ipod Part. All of that will get you into Factory Service Mode.
5)Make sure the PS3 has no Power on,
6)Plug the Ipod In the the left most USB Turn Ipod On. Than switch on Ps3 or Plug in cord. click the power button on followed by the eject button soon after. Your PS3 should Shut off after a couple of seconds.
7)Unplug Ipod.
Turn on The PS3 normally and youll notice its in factory service mode in The Red Box.
Do not Hard Reset just shut it down with the controller.Back to the Computer--------------------------------------
USB Drive-Downgrade Files:USB Drive-Downgrade Files:You must login or register to view this content.
NOTE:--You Can get the 2.10 Update anywhere try Ps3hacks
1)get your USB flash drive make sure its Fat32 Format and has more than 300MB
2)Place Lv2diag.self & PS3UPDAT.PUP in the root Of the USB.
NOTE:--You Can get the 2.10 Update anywhere try Ps3hacks
1)get your USB flash drive make sure its Fat32 Format and has more than 300MB
2)Place Lv2diag.self & PS3UPDAT.PUP in the root Of the USB.
You must login or register to view this content.
3)Safely remove USB from system by Eject
4) Plug in the Right most USB of the PS3.
5)Turn on PS3 NormallyYou will Not See anything on screen. wait 2 to 6 Minutes Untill it shuts down on its own.
6)Unplug the USB from the PS3 and Turn it On as Normal and there you go you are now on Version 2.10 Firmware.
Note you will still be in service mode still,to get out of service mode
Turn OFF PS3 with Controller DO NOT UNPLUG / SWITCH OFF POWER
Download this You must login or register to view this content.
1)Format your USB and Place this On the Root of the USB Stick.
2)Eject from Computer,and Put into PS3 in the right most usb slot.
3) turn on PS3 wait about 6 seconds until Ps3 Shuts itself off.
4)Unplug USB Stick from the PS3 and turn on ps3 then UPGRADE to VERSION 3.41 and Start Hackin.
Note: I have not ran into any problems Other Than No BluRay PlayBack but later may be Fixed. If Any Body has a Fix please Pm me, so if anything bad happens I am not Held Responsible. Thank you
Thank is appreciated. :love:
so if I am right I can jailbreak the ps3 with the nano aswell?
Copyright © 2026, NextGenUpdate.
All Rights Reserved.
