(adsbygoogle = window.adsbygoogle || []).push({}); i was on firmware 3.55 and i put wanikokos firmware ontop of the ps3 jailbreak so i could donwload my games to my hdd so my ps3 froze half way then shut off now all i get is green light... yellow light... 3 beeps and then a continuous flashing light that wont stop untill i press the power button again.

so can anyone help me fix this??

thts yellow light of death not brick, the best u can do is find the guarantee ticket or fix it

i know its ylod i remember that ylod is when a ps3 turns green light than yellow following after red lights blinking till you hit the power button...

my ps3 fat died from that way R.I.P

my fat ps3 is still kicking its done that like 7 times to me but i fix it every time just need some flux next time it ylod tho

/facepalm... Yellow light means a hardware failure. As in the fact you would have to reflow / get it reballed or buy a new one

You must login or register to view this content.


How to fix the Wankybrick for NAND consoles
Posted on February 6, 2011 by rms
OK, so we all know about how the original Waninkoko firmware broke the older large NAND consoles, that was due to him overwriting some portions of Cell-OS Lv2 and the segment boundaries, god knows about the signature also. He also zeroed out a good section of the kernel, and also breaks some NAND consoles due to that. Now, you want to fix this issue? Well, you have to have:

1) A NAND Dumper
2) CORE_OS_PACKAGE.PKG patched to remove signature checks or Official Core OS/PS3 in Service Mode
3) A NAND Flasher
4) Flow Rebuilder
5) Hex editor
6) PS3 with firmware less than 3.55

OK, so you first have to dump both NAND chips (2 128MB NANDs for a total of 256MB) and interleave them using Flow Rebuilder, then decrypt the CORE_OS package to give you a raw core OS image, then open your combined NAND dump in a hex editor and search for “6F FF E0″ in the search for hex section. Once there, you should see:

00000000 00 00 00 00 00 00 00 00 00 00 00 00 00 6f ff e0 |.............o..|
00000010 00 00 00 01 00 00 00 17 00 00 00 00 00 6f ff e0 |.............o..|
Right after the second “6F FF E0″, remove the next 7,340,000 bytes, then, insert the unpacked Core OS (7,340,000 bytes). Then split the image using Flow Rebuilder (use ECC!) and flash. Hopefully it should work, and then you can just Lv2diag your way out.

Do not overwrite anything else.

This guide should help you fix any NAND console with Core OS fail.

do you have a.... ummm..

A NAND Dumper, a CORE_OS_PACKAGE.PKG patched to remove signature checks or Official Core OS/PS3 in Service Mode, A NAND Flasher and a Flow Rebuilder i can borrow...

ohh yea and wana help me solder the nand dumper and flasher

I think that is the yellow light of death not a brick so new ps3 for you

there is the ylod and what it looks like

wininkoko's cfw does that to the ps3 its brick i know for sure cause if u look up waninkokos brick all ps3's do that same thing