Post: How To Fix Cex To Dex Brick
Options
05-29-2013, 12:40 AM
#1
alex9153
Haxor!
How To Fix Cex to Dex Brick
BEFORE YOU START YOU MUST HAVE A E3 FLASHER
This brick seems to be the yellow light of death but its actually not
1. You have to open up your ps3 and install the E3 flasher
2.Once you have installed the E3 flasher you have to connect your Nor tristate you can locate that based on your mother board ( on e3 have the first button up find what mother board you have and find the Nor tristate and your GND) you can solder a wire from the Nor tristate to the GND or you can hold the wire their for 30 seconds all depend on you.
3. Once you have done that and turned on the ps3 to make sure it does not turn off you have to have the 1 button up and 3 button up and the rest down (This step is for the people that lost their dump/bkpps3.bin if you have your dump and is valid skip to step 5) click start and get your dump.
4. THIS STEP IS IMPORTANT YOU MUST CHECK THAT YOUR DUMP IS VALID IF IT IS NOT DO NOT CONTINUE!!!!! AND DO IT AGAIN TILL YOU GET A VALID DUMP.
5.Once you have made sure your dump is valid take your micro sd card and put it in the slot in the e3.
6. Press start and wait till it finishes (once done you can take off the wire that you soldered from the Nor tristate to the GND).
7.Rebuild your ps3 and your done.
You are going to have your ps3 open so the only things needed connected is the fan the battery and your turn on and off buttons
The following user thanked alex9153 for this useful post:
06-17-2013, 08:30 PM
#11
UniversalClan
Save Point
Copyright © 2026, NextGenUpdate.
All Rights Reserved.
