, Vid tho
)ok Once removed put to the side and the check the controller find the R1 button and remove. OK there should be a clasp holding 2 buttons in to the r1 board. ok Once the clasp is removed what i want you to do is rip the two buttons in half ( down the middle) THen keep the bigger button the one for R2. I also want you to remove a small part from the R1 bit of the clasp. This is so the paperclip and be free in games to use. its on the right like when your holing the contoller propely. Remove that small section and were ready to mod.Start Drawing over the board with the R1 button in pencil. The graphit helps the paper clip conduct easier to complete the circiut.Nwo bend the paper clip in such a way that one of the heads is toching the R1 button and the over is streched out like a trigger.We ready to stick it to the board.Be carfully and have plenty sticky tape , this may take a few tries.Once one of the paperclips heads are stuck to the r1 button is ready to put the controller back together , Be gental that paperclip and pop out any time tho.Once its all good we simple screw it back together and try on the ps3. And your done
! caution this may take some time to get the paperclip in a perfect postion.Once you have found it and stuck it in really well
you will be owning with the G3 in no time 
only did it to show you guys its possible.
did it witha webcam sorry
Copyright © 2026, NextGenUpdate.
All Rights Reserved.