(adsbygoogle = window.adsbygoogle || []).push({}); found by me xELiT3_Sn1PaXx
Im not going to give all of it to you as it took me a while to figure out

first - we can have 1kb (1070 bytes) in a CM/MP file
second - default controlls controlled by .cfg
so that gives us about 4-5 kb right there

we have to allow us to go to the .cfg file so in Grad0_mp anywhere type

    

bind button_back "exec (button controlls).cfg"

then use this to allow our custom exec

    

set autoexec_enable "1"

then we can add more codes to it later

then we have our managed grad0_cm file (controlls)
so that is our (button controll).cfg file
so type your "codes" in.

once done save your cm file as (button controlls).cfg

now open it in hex editor

find all the 00's at the end. you can delete them or add em untill your file is 4-5 kb and you can add more menus

and your done

but you guys nees to find
-----------------------------
• buttons controlls the (type of controlls).cfg
-----------------------------

you guys should get this working in no time

REP+ if you like tgis tutorial

Take a picture on ipod, upload it to facebook, put link.

but the internet is sooo slow.
Im stealing free wifi

WIFI PERCENT = 12

It would take like 6 hours if that

ughhh ok take out the func to make file bigger and post ur codes

naw my mistake man But doesn't your config file need to be in the patch :confused:

actually .. . NO

as long as in mp you have something to locate the .cfg like

PS3/SAVEDATA/BLUS30377(whatever it is)/config_mp.cfg

And that just goes into your mp or cm file or what?