(adsbygoogle = window.adsbygoogle || []).push({}); Hello there,

My name is Roah, i recently bought a new Ps3 and because i already got a E3 Flasher i wanted to jailbreak this ps3 too. Everything was fine but after i flashed the ps3 it turned off, so i tried to turn it back on but after a few seconds the ps3 completly shuts itself down. i am able to turn it back on by pressing the on button, but then it shuts itself down.

Before i tried to downgrade my Playstation 3 i created a backup dump, i checked it with rogero's dump tool and it was a 100% valid dump ( i saved it on my desktop ) , so i searched over the internet and i came to the conclusion that i needed to solder the NOR Tristate and GND. I've no idea what I need to solder, and if i'm able to use the E3 flasher again on a other ps3.

I've also got a question, do i need to use a wire to connect it, or is it alright to use tin only instead of a wire? Forgive me my stupidness, i'm just trying to learn more stuff. I would appreciate any help, and if possible some pictures about what i need to do.

Thanks in advance,

Roah

Bricked invalid dumps don't always believe the tools. Should of made multiple dumps and made sure they where all identical and valid then patch it with a 4.50 flash tool. Once you do that you check your patched dump was valid then flash with E3 flasher. Also your clip may of came loose during flashing process. To solve this you need to solder or even tape a wire to y=and GND point on your PS3 motherboard then to your tristate that will power on your console for you to get valid dumps again then flash.

Hello there,

Thanks for your quick reaction to my thread!, i really appreciate it. But what do you mean with solder a wire to y=and GND. am i amble to use tin instead of a wire?, and how can i locate the points i need to solder.

Thanks in advance!

Sorry i meant to say gnd point to tristate. I think that should be good. Just type your motherboard number in google for example DYN-001 GND point and you should find it.