(adsbygoogle = window.adsbygoogle || []).push({}); Hey guys I have my 3.70 ps3 and when I turn it on I get a update loop and at around 8% it gives me the error 8002f14e my bluray drive works fine so idk whts wrong can u help me plz thx

Try booting it into recovery mode by doing this

1. Make sure ps3s off red led
2. Hold power button down untill ps3 turns on and keep holding till it powers off
3. Hold power button untill you hear a double bleep
4. Add your control with a usb charge cable
5. Navigate to UPDATE
6. Make sure you have 3.70 UPDATE or what ever update it is in your usb like this PS3/UPDATE then the update in UPDATE then plug the usb into your ps3 then select UPDATE then follow the on screen instructions

"Please note that these ranges are just a rough guideline and that the problem maybe different so try the next closest percentage range!

0%-40%
Cause: At this point the update is verifying and unpacking files from the .pup, then updating files on the NAND (and HDD for newer consoles with NOR flash). In 9/10 cases any failures at this point are due to a corrupt update file which happens pretty easily if it has been downloaded over a poor wireless network or poor connection in general. Otherwise in rare cases there could be a write failure to flash which I have NEVER witnessed.
Fixesownload the latest update version and prep a USB stick into FAT32. It maybe a good idea to double check the MD5 of the file to be certain it is a 1:1 copy once downloaded. Place the update named 'PS3UPDAT.PUP' on the USB device inside the correct folders (for example: F:\PS3\UPDATE). Anywhere else and the PS3 will not see the file. Swap out the current hard drive in the PS3 for a spare one, it doesn't have to be formatted or anything like that as the PS3 will do it for you. Now you will have to turn the console on but instead of booting it normally, put it into recovery mode. For anyone who doesn't know how to do that: hold the power button until the console turns on then off again, take your finger off and hold it down again so the console turns on again then wait for it to beep twice in quick succession before removing your finger. The console should then ask for you to connect a controller via cable and press the PS button. Once in recovery mode put your USB stick in any port and then choose the 'System Update' option. It will format, prepare and hopefully install the update without any further error."

So, basically re-download the update and like RAB said go into Safe/Recovery mode to install it.

I can't get into recovery/safe mode

Question is that you can't cause you
don't know how?
or
the ps3 wont let you?

press and hold power button it will turn on then turn back off then press and hold the power button again you will hear a first beep then you will hear a double beep then let go then you should be in te recover menu.

The ps3 won't let me it goes right back to updating

try formatting the HDD and try again

I've tried tht switching between to systems had and never worked

I switched back between my two hard drives it brings me to the recovery menu then I update it almost gets done and then when it installs back in the update loop