(adsbygoogle = window.adsbygoogle || []).push({}); A few months ago I downgraded my ps3 and installed custom firmware, all went fine until I tried to go from Rogero to Rebug because I forgot to take a disc out of the tray and it messed up the firmware. I then re-flashed using my E3 Flasher and now when I turn on my ps3 the fan slows down and there is no picture going to my tv and no power going to the usb ports, My dump is fine and my ps3 stays on for as long as I want, just I can't use it. I've been told by friends it might need thermal paste is this correct? Anyone know how to fix this? Whoever helps me fix it gets 3 free services on their games of choice or 50 free platinum trophies as a thank you gift.

Not Too sure , Could be GLOD. Try Reflowing.

Dont know whats going on there but maybe this might help ? You must login or register to view this content.

you have GLOD meaning you have damaged your RSX or its dieing

try reflowing it with a heat gun.

i had the same problem i just brought a another cfw..

I'm going to try and reflow it, If I fail I might just buy another cfw or maybe buy a jtagged xbox.

GLOD = Green Light Of Death ?



What CFW you are using..? I saw one of your posts says that you have your ps3 going to 80's (Cell temp) in IDLE state and that is fine, after playing few hours the temp gets lower (because the fan started working).. I just have your similar situation is that safe =3? Or I have to use #PayLoad in control fan utility?

Mine is on 4.50ps3ita RSX is damaged (bloody dex brick caused this) just normal fans speeds
my another is fat RSX Around 64 And cpu 76

check Hard drive light it will make a light if the ps3 is going to boot