(adsbygoogle = window.adsbygoogle || []).push({}); Ok, i have downgraded over 60 consoles with the e3 flasher... i did everything right.

After i rebuilt it, it said Connect a controller via usb cable... press the ps Button...
after that it started to install the cfw that i always use to finish the downgrade..

after it hit 20% the ps3 shut off and now the ps3 starts up and cuts off 1 second after...
NOTE: Its not YLOD/ RLOD, it starts up and a sec later it turns off quitely and no beeps.
After Reflashing the NOR backup, it shuts off after 4 seconds...

UPDATE: PS3 Now runs without a shut down, but there is no video or HDD response.

I also found out it had Cod Ghosts in the disc drive, and was wondering if that fucked up the firmware installation... and i want to know if there is a way to install a Firmware using the e3 flasher?

Or get it somehow to recovery mode without a Shut down...

I have already tried:
- Get into Recovery mode( before and after Reflashing Nor)
- hold buttons down at start up for anything to happen,
- Removed the disc from the Disc drive
- Change HDD from the ps3, and tried running without one.

Please help me help will be greatly appreciated

When i am doing downgrades i never have the disk drive connected so i can upgrade pull the e3 flasher off and install the firmware...

Take out the e3 flasher and try again.

I checked the flash, and its perfect... im redoing the downgrade steps but i dont think its going to help, i need a way to reinstall the ofw.. using flash fun mode

Already tried that, If the ps3 is not on Flash Fun mode (e3 flasher) then the ps3 wont stay running, so i cant really install any firmware as of what i tried. thanks for the help tho.... I still need help :/

No I'm saying take out the E3 clip and make sure the console is working then re-downgrade.

I DID! and i re dowgraded it, It now just runs normally but no video or HDD response :/

Can you get into recovery mode after reflashing?
Hmmm, I would reflash again your PATCHED bkpps3.bin again with flashfun, meaning having the wire from GND to NOR TRISTATE connected. Once that is done, I would continue with the installing the CFW and format the HDD if anything.

If not, the reflash your ORIGINAL bkpps3.bin and see if it starts working?

Also, is the FAN working?
is there Thermal paste on the chips?

you need to check all the soft wires and wires of the ps3 hardware connected propoerly....