(adsbygoogle = window.adsbygoogle || []).push({}); Ok, i have downgraded over 60 consoles with the e3 flasher... i did everything right.

After i rebuilt it, it said Connect a controller via usb cable... press the ps Button...
after that it started to install the cfw that i always use to finish the downgrade..

after it hit 20% the ps3 shut off and now the ps3 starts up and cuts off 1 second after...
NOTE: Its not YLOD/ RLOD, it starts up and a sec later it turns off quitely and no beeps.
After Reflashing the NOR backup, it shuts off after 4 seconds...

UPDATE: PS3 Now runs without a shut down, but there is no video or HDD response.

I also found out it had Cod Ghosts in the disc drive, and was wondering if that fucked up the firmware installation... and i want to know if there is a way to install a Firmware using the e3 flasher?

Or get it somehow to recovery mode without a Shut down...

I have already tried:
- Get into Recovery mode( before and after Reflashing Nor)
- hold buttons down at start up for anything to happen,
- Removed the disc from the Disc drive
- Change HDD from the ps3, and tried running without one.

Please help me help will be greatly appreciated

look at the hdd indercator if it doesnt do it means your RSX is damaged Meaning No Video Input Or Controller input

I believe it is a rsx damage, because it runs fluently now, but no video response... im going to get that fixed now.

I had this problem, i restored my ps3 using the e3 flasher and tried again it's usually the patcher but i downgraded it sometimes does go to the recovery but the first time i did it, it said the data is corrupt and the second time i did it, it installed the firmware correctly i did this today.