(adsbygoogle = window.adsbygoogle || []).push({}); I was on 4.75.2 Rebug DEX,I was trying to switch back to CEX for a little. So my lvl 2 kernel was CEX and my target type was DEX, after i clicked "swap target type" under switch kernel. my ps3 then reboots into this
You must login or register to view this content."The system software cannot be run correctly, Press the PS button to try to restart the system.(I've tried and nothing worked)
If the system cannot be restarted, you must reinstall the system software.
Connect storage media that contains update data of version 4.75 or later, and then press the START and SELECT buttons at the same time.

so i tried many different PUPs and even downgrader PUPs and nothing worked(i dont want to use an OFW PUP cause i dont wanna lose my cfw and cant afford another cfw) i tried doing it many times and on "preparing to update, it goes fast then when it hits 89% it starts of very slow then when it hits 98% it stays stuck forever. please any help will be very appreciated guys thank you
You must login or register to view this content.

hits 98% it stays stuck forever"""""" how long have you waited? sometimes it can take a few minutes.
and was it a cex/dex .pup?

about 10-15 minutes stuck on 98 and i was using rebug 4.75 rex pup and rebug 999 downgrader pup rex i know for a fact my ps3 is on full cex mode right now i just dont know what to do im really scared that my ps3 might be done for idk.. this is a DEX to CEX semi brick i guess you would call it.
edit: how do i provide a picture ive taken of the screen on here

yeah 10-15 mins is to long,
if u think it made it to cex: install 4.75 rex
if u think its dex: install 4.75 D-rex

it will take one of the 2. if not, check usb folder structure/format ect.....

when i insert dex pups, it says no applicable data was found, when i put rex/cex pups it gets stuck at 98% idk what to do

re download 4.75 rex
re format the usb
copy it back to usb and try it

note: yes u did make it to cex, ie: its asking for 4.75 or higher. if u were still dex it would ask for your base fw or higher

But when I reinstall rex rebug, it gets stuck on 98% see picture?

you re downloaded it & and reformatted the usb
if so
try it in recovery mode

Rephrase that again please

ok
did you


re download 4.75 rex
re format the usb
copy it back to usb and try it


if it still wont go


try it in recovery mode