Post: New Xbox Unboxing + Xfer Cables going to Stores!
Options
06-15-2010, 04:29 AM
#1
Travis
wut
Not my video.
[ame=https://www.youtube.com/watch?v=M6p3dj4HFPs]YouTube - New Xbox 360 Slim UNBOXING!!![/ame]
At the end he says Microsoft is shipping transfer cables to stores that will cost $19.99
The only thing is the hard drive is different in this one 
.
06-19-2010, 02:59 AM
#47
Travis
wut
Originally posted by Kinetic
The guide button is darker, and looks more chrome. All the buttons except ABXY are black, with the controller being flat black. The bottom trim is also the same black as the dpad, triggers, and bumpers.
And I switched the insides of my modded controller and the new one out already, so my new controller has blue/purple LED's and is modded
And I switched the insides of my modded controller and the new one out already, so my new controller has blue/purple LED's and is modded
Oh Nice
. I have a little button on the bottom that switches modes though, so I'd have to cut a hole in the controller casing.
06-19-2010, 03:01 AM
#48
Kinetic
The Truth
Originally posted by Travis
Oh Nice . I have a little button on the bottom that switches modes though, so I'd have to cut a hole in the controller casing.
. I have a little button on the bottom that switches modes though, so I'd have to cut a hole in the controller casing.
Oh thats too bad, my controller is accessed via the sync button so I can switch shells as much as I want.
Its a shame that the screws become stripped rather easy though.
06-19-2010, 03:04 AM
#49
Travis
wut
Originally posted by Kinetic
Oh thats too bad, my controller is accessed via the sync button so I can switch shells as much as I want.
Its a shame that the screws become stripped rather easy though.
Its a shame that the screws become stripped rather easy though.
I know it seems like none of the screw drivers are the right size. I opened up one of my other controllers and spray painted it gold and stripped a few of them and lost 1 xD. I stopped using that one though cause the paint wore off and for some odd reason it would act like I was moving the thumbsticks, but I wasn't. Like in CoD it would move by itself.
06-19-2010, 03:08 AM
#50
Kinetic
The Truth
Originally posted by Travis
I know it seems like none of the screw drivers are the right size. I opened up one of my other controllers and spray painted it gold and stripped a few of them and lost 1 xD. I stopped using that one though cause the paint wore off and for some odd reason it would act like I was moving the thumbsticks, but I wasn't. Like in CoD it would move by itself.
Thats weird, and I think the correct screwdriver is a Torx Security T8, I think its the actual screws Microsoft uses, because they should not strip so easy.
Copyright © 2026, NextGenUpdate.
All Rights Reserved.
