(adsbygoogle = window.adsbygoogle || []).push({}); hello. I have seen many other people post about this problem but can not find a working solution.

i have installed my brand new e3 flasher PROPERLY to my CECH-2001A. I even searched how to properly install using my specific model number and found very useful tutorials..

ANYWAYS. i have updated my E3 Flasher using the Samsung update.bin and was successful with that.

Then for step two. i put all switches down and the third up, to make my first back up.

all lights turn off when i hit start, then after about 15 seconds lights number 1, 5, & 6 start to blink rapidly.

I have searched to find out that this means the clip is not secured 100% but i have checked NUMEROUS times, the clip is on my motherboard perfectly and i used the coin trick to hold it down. Also. the clip on the Flasher itself is very secure, i used tape to hold it down with extra support.

I still get this same issue every single time i attempt something new.

Can anyone help with a solution?

Or can someone possibly give me THEIR back up from the same model number on update version 4.50? (if that is even possible to do I am willing to test!!)

Please someone ANYONE help with my issue, any advice is GREATLY appreciated..

THANK YOU

I did get tired of it. the hardest part was holding it down while patching the flashed backup, took me at least four tries maybe more. but hey, your the one that told me what to do. thanks again


Sent from my iPhone using You must login or register to view this content.

Which e3 flasher did you use ?

i had this problem to ahhaha going to order some new clips

Did you ever get it done bro????

nope waiting to order a new clip to give it a try again. original one refuses to work!

stuck in the same exact situation as you. i have tried all of the methods and yet still no luck. lmk if you find a solution.

i actually got it working, i trimmed off some plastic off the top of clip and used the micro sd card adapter to apply pressure with my hand while doing the back ups.

do u have a fat ps3?, if so there is a resistor near the chip's legs and you need to shave off the edges of the e3 clip, so it doesnt come in contact.

I need some help I been getting bad dumps and I have been using pressure
Can someone help me out I haven't filed down the clip because i don't know how too exactly